After performing an Archive and Install installation, you should reinstall Palm Desktop software and the iSync Palm Conduit before syncing your Palm OS-based device.
After an Archive and Install installation, you might see this alert when you log in: "Transport monitor could not be launched because of a shared library error," and you can't sync with your Palm OS-based PDA.
Locate the "HotSync Libraries" file in your Previous System folder, and drag it to: /Library/CFMSupport/
Alternatively, or if your Previous System folder is not available:
• For iSync 2.0 or later (included with Mac OS X 10.4), enable Palm Conduit in iSync. Note that there are other steps in the process of setting up a Palm OS-based device, such as opening HotSync Manager and checking conduit settings. Check out this document.
• For iSync 1.5, reinstall Palm Desktop, which is available from this Palm website. If you use iSync with your Palm OS device, you will also need to reinstall the iSync Palm Conduit after Palm Desktop. The iSync Palm Conduit is available here.
Important: Mention of third-party websites and products is for informational purposes only and constitutes neither an endorsement nor a recommendation. Apple assumes no responsibility with regard to the selection, performance or use of information or products found at third-party websites. Apple provides this only as a convenience to our users. Apple has not tested the information found on these sites and makes no representations regarding its accuracy or reliability. There are risks inherent in the use of any information or products found on the Internet, and Apple assumes no responsibility in this regard. Please understand that a third-party site is independent from Apple and that Apple has no control over the content on that website. Please contact the vendor for additional information.