Here are some troubleshooting steps to follow if you have system "crashes" or
"freezes" when using MODE32:
* If your Macintosh "freezes" before the Welcome to Macintosh dialog box is
displayed, additional hardware, such as NuBus cards, system accelerators or
memory may not be 32-bit clean. In this case, contact the manufacturer of
your third-party hardware. ╩
* If your Macintosh "freezes" when the Welcome to Macintosh dialog box is
displayed, your hard disk formatting software may not be 32-bit clean.
You should update your hard disk driver.
* If your Macintosh "freezes" while it is loading INIT files, remove all INITs
except MODE32, then reboot your system. If your system reboots normally,
add the INIT files one by one to your System Folder and reboot after you add
each one. If your Macintosh "freezes" again, the INIT that you just added
is likely to be incompatible. Contact the INITs vendor to get an updated
version.
Note that INITs that are NOT 32-bit clean are likely to be incompatible.