You may move ThinkTank (Living Videotext) to the hard disk. This will allow
you to access it with greater ease than using floppy disks. These instructions
assume you are moving ThinkTank to a ProFile (with a driver name .PROFILE).
Substitute the name of your hard disk driver for .PROFILE if you wish to
install ThinkTank on a different hard disk.
COPY PROCEDURE
1. Boot the CATALYST diskette (if you haven't already).
2. From the main CATALYST menu, select the Systems Utilities Program.
3. Press "F" for File Handling Commands.
4. Press "M" for Make a New Subdirectory.
5. Enter ".PROFILE/CATALYST/THINKTANK"
6. Press RETURN to accept the default size of 25 files.
7. Press ESCAPE.
8. Put the THINKTANK PROGRAM diskette in the internal drive.
9. Press "C" to copy files.
10. Copy all files from your PROGRAM disk to ".PROFILE/CATALYST/THINKTANK/="
except for the following:
SYSTEM.STARTUP SYSTEM.MISCINFO SYSTEM.PASCAL
To do this, type ".D1" and press the up arrow key. A list of files are
displayed in a box. The up and down arrow keys allow you to move an inverse
bar over the name of your choice. Pressing the right arrow key marks the file
so as to include it in the copy process. Mark all files to be copied in this
way. When all files are marked, press RETURN.
11. When all files have been copied, Press ESCAPE.
ADDING THINKTANK TO THE CATALYST MENU
1. Return to the Catalyst main menu.
2. Select the Catalyst Editor.
3. Enter "E" to edit the menu.
4. Use the up and down arrow keys to position the inverse bar over the entry
you want the program to precede. Press "A" to ADD a program entry.
5. You will be asked for the display name of this program, enter "THINKTANK".
6. Enter "CATALYST/PASCAL" as the interpreter path name.
7. You will be asked if you want "EXTRA DRIVERS". Press RETURN.
8. Press RETURN for standard character set.
9. Press RETURN for the normal screen.
10. Press RETURN for the default keyboard.
11. Press RETURN for the initial prefix.
12. Enter "3" for the "Max Files Allowed..." question.
13. Enter ".PROFILE/CATALYST/THINKTANK,TANK.CODE" for the program path.
14. You will be asked if this entry is correct. If it is, enter "Y" then press
ESCAPE to exit to the main edit menu. If you made any mistakes during entry,
enter "N". You may then enter the number of the item you wish to correct. When
all items are correct, press ESCAPE. Press ESCAPE again to exit to the main
edit menu.
15. Enter "5" to update the INTERPS file. When you are asked if you want to
recalculate the load address, enter "N".
16. Exit to the Catalyst main menu by entering "Q".
NOTE: Apple Computer Inc. is not responsible for the contents of this
article.