Here are some things you can do to increase performance:
1) The most significant performance increase you can configure is to
allocate as much memory to SoftWindows as possible.
2) Make sure Virtual Memory is turned off.
3) Decrease the disk cache to 96K (the default) in the Memory control
panel.
4) Make sure at least 2 MB of RAM is left over from the difference between
the memory partition allocated to SoftWindows, and the memory allocated
under PC Memory in the Setup menu of SoftWindows. Don't allocate EMS
memory, but use XMS memory only. For example, if you have 18 MB
allocated to SoftWindows. Run SoftWindows, go to the "Setup" menu, and
select "PC Memory". Make sure EMS memory is set to 0, and set Extended
Memory (XMS) to 8 MB. Since SoftWindows needs about 10 MB for itself,
this would leave roughly 2 MB for what's called the "Delta Cache", which
should speed things up. For future reference, take the total amount of
memory allocated to SoftWindows, subtract what you set up in the PC
memory menu, subtract 10Mb, and that's roughly what you have left for
the Delta Cache. You always want the Delta Cache to be about 2 MB - no
less.
5) Set the monitor bit-depth to 256.
Insignia Solutions has a FAX-BACK system that you can call to get this
information. The document number is 305. The Fax system phone number is
800-876-3872.
Support Information Services