PROBLEM DESCRIPTION: After the Monitor II has had a chance to
warm up, there is no display or faint display or fuzzy display.
WARNING: Turn off the Monitor II and unplug it whenever the
case must be removed for the procedure below.
CAUSE: 1. The video connector is either not plugged in all
the way or the video jack may be cracked.
2. The regulator is plugged in upside down or cracked.
CURE: 1. Plug video cable into the jack all the way and make
sure the connector is not broken and fits snugly.
2. Replace regulator. Be sure to use heat sink compound
before tightening it down.
If the above cure doesn't solve your problem, refer to the Tech
Procedures to obtain the general troubleshooting procedure for
this product.