Once an external SCSI device is connected to the 25-pin external connector, the circuitry senses the device and disables termination at the 50-pin logic board connector. The computer then relies on the external SCSI device to provide the proper termination.
Bus 0
Bus 0 is a completely separate SCSI bus with its own SCSI controller. This bus has a 50-pin flat ribbon cable with two 50-pin connectors on it. Power Macintosh 8100 series computers ship with the internal hard drive connected to this SCSI bus. The internal hard drive is terminated, which terminates the SCSI bus.
Unlike Bus 1, Bus 0 does not have automatic termination because it is exclusively an internal SCSI bus. If additional devices are added to Bus 0, only the last device should contain termination resistors.
Power Macintosh 7500, 8500, and 9500 Series Computers
Bus 1
Unlike Bus 1 in Power Macintosh 8100 computers, there are no devices attached internally to Bus 1 in Power Macintosh 7500, 8500, and 9500 series computers.
Bus 1 has automatic termination, which means that circuitry on the logic board senses whether or not there are any external SCSI devices attached. If there are no external SCSI devices connected, the logic board automatically terminates itself at the 50-pin logic board connector, thus terminating both ends of the SCSI chain.
Once an external SCSI device is connected to the 25-pin external connector, the circuitry senses the device and disables termination at the 50-pin logic board connector. The computer then relies on the external SCSI device to provide the proper termination.
Bus 0
Bus 0 is a completely separate SCSI bus with its own SCSI controller. On Power Macintosh 7500, 8500, and 9500 series computers, Bus 0 provides Fast SCSI communications up to 10 MB per second.
This bus has a 50-pin flat ribbon cable with two 50-pin connectors on it. Power Macintosh 7500, 8500, and 9500 series computers ship with the internal hard drive and CD-ROM drive connected to this SCSI bus. The internal hard drive is terminated, which terminates the SCSI bus.
Unlike Bus 1, Bus 0 does not have automatic termination because it is exclusively an internal SCSI bus. If additional devices are added to Bus 0, only the last device should contain termination resistors.