Apple III: Cables for Various Printers (2 of 4)

Apple III Drivers Aid Cable "C"

Device Manufacturer and Models:
Diablo           620
Diablo           630 (Use as shown; DO NOT change pin 20!)
Diablo          1630
Diablo          1640
Diablo          1650
Xerox            630 (See change; this model ONLY; re: pin 20)
Xerox           1710
Xerox           1720
Xerox           1730
Xerox           1741
Xerox           1750

Pin-to-Pin Connections:

Apple III (Male)         Diablo or Xerox (usually Female)

1 o----------------------------o 1
2 o----------------------------o 3
4 o------------------------+---o 6
                           +---o 8
6 o----------------------------o 20 (on Xerox 630 ONLY
                                     go to pin 11
                                     instead of pin 20)
7 o----------------------------o 7
                           +---o 4
                           +---o 5

Wiring Comments:

Apple III pin 4          Tie device pins
tie to device pins       6 + 8 together
6 + 8
                        Tie device pins
                        4 + 5 together; they do
                        not connect to the Apple III

                        Change pin 20 to pin 11
                        ONLY for the Xerox 630!

Note:  For proper operation when using the Apple III Super Serial Card (Apple
P/N A2B0044) in an Apple III make sure that switch SW 2-6 (on the card) is in
the "ON" position and that the jumper block (also on the card) is in the
"TERMINAL" Position.

Apple III Drivers Aid Cable "D"

Device Manufacturer and Model:
Texas Instruments 810
Centronics        737

Pin-to-Pin Connections:


Apple III (Male)         Texas Instruments (usually Female)

1 o----------------------------o 1
2 o----------------------------o 3
4 o------------------------+---o 6
                           +---o 8
6 o----------------------------o 11
7 o----------------------------o 7

Wiring Comments:


Apple III pin 4          Tie device pins
tie to device pins       6 + 8 together
6 + 8

Note:  For proper operation when using the Apple III Super Serial Card (Apple
P/N A2B0044) in an Apple III make sure that switch SW 2-6 (on the card) is in
the "ON" position and that the jumper block (also on the card) is in the
"TERMINAL" Position.

Apple III Drivers Aid Cable "E"

Device Manufacturer and Models:
Okidata 82A
Okidata 83A

Pin-to-Pin Connections:


Apple III (Male)         Okidata (usually Female)

1 o----------------------------o 1
2 o----------------------------o 3
7 o----------------------------o 7
20 o----------------------------o 11
                           +---o 6
                           +---o 20

Wiring Comments:

                        Tie device pins
                        6 + 20 together; they do
                        not connect to the Apple III

Note:  For proper operation when using the Apple III Super Serial Card (Apple
P/N A2B0044) in an Apple III make sure that switch SW 2-6 (on the card) is in
the "ON" position and that the jumper block (also on the card) is in the
"TERMINAL" Position.  Apple III Drivers Aid Cable "F" description on next
record.
Published Date: Feb 18, 2012