PowerDomain is the control panel that allows users to make card-level changes. These options are described in the Adaptec documentation.
Go to the control panel and select the Adaptec card.
Pick Automatic from Termination Options.
Parity should be ON.
Leave the card ID at 7.
Pick Target Options from Special.
Pick the ID of the hard drive in question.
For transfer rate, pick the number nearest the transfer rate of the drive.
Allow Disconnect and Wide Negotiation.
If your drive is an Ultra Wide, allow Ultra SCSI.
Click Set to save the settings and close all open stuff, then restart.
Revert: There are two different revert options. The first is under the board option in the menu bar. This will revert the card settings. The second is in the control panel itself. This will revert the control panel settings.
Flash ROM: This will allow the user to update the flash ROM on the card. For this option to work, the customer must have the flash ROM application from Adaptec. Updating the ROM should be done as the new ROM versions are released and in limited cases where there is a possible card level problem.
Machines Affected: All