Users report that using the older version of MacPlot (1988 &1989) under 7.0, only parts of a color drawing were printed. Plotter would start to plot, switch colors, and never return to original color to finish objects. This was corrected by installing version 1.2.
However, updating from one driver to the next causes problems. Here are some workarounds:
- Re-install the system software
- Install new version of MacPlot and configure it.
- Choose another driver (e.g. LaserWriter)
- Open drawing that was not plotting correctly, chose page setup. Click Ok.
- Choose MacPlot Driver, choose page setup.