AppleTalk Remote Access: Uses Portions of Comm Toolbox

I understand that AppleTalk Remote Access doesn't use the Comm Toolbox because of speed issues. Is it possible to change AppleTalk Remote so that it recognizes the extra ports Comm Toolbox allows access to?

I noticed that in the "Remote Access Setup" CDEV that I can see the extra ports, but can't select them. Could you allow the user to select these serial ports? If not, the extra ports should be hidden.
AppleTalk Remote Access does use portions of the Comm Toolbox. At least one serial card was tested with AppleTalk Remote Access that allows you to select the serial ports on the card. The card is the QuadraLink from Applied Engineering.
Published Date: Feb 18, 2012